PureFlow AirDog Universal Fuel Module Upgrade Kit Installation Instructions This Kit Includes: Please verify all parts are included before beginning i
10 Step 8. Slide the soft pickup tube assembly onto the bulkhead fitting and fasten with supplied spring clamps as shown. Next, route soft plasti
11 Step 11. Next drill two more holes, one on either side of where the tube will be in bottom of module (fig 11). Figure 11 Step 12. Slide t
12 End result: You should have a new suction tube that goes all the way down to the bottom of the sending unit, be sure to drill holes where in
2 INSTALLING THE PUREFLOW® FUEL MODULE UPGRADE! To access the fuel tank to install the Up Grade Kit, it is necessary to either drop the fuel tank
3 For Fuel Module “A” In-tank style Note: The sending unit pictured may not be the exact same as the one you have, however installation procedure
4 An alternate method is to cut the black plastic supports (there are 3) around the top of the pump that are attached to the basket and remove ent
5 Step 5. Install the ½” quick connect fitting into the bulkhead fitting (fig 10). Use diesel compatible thread sealant tape on the NPT threads
6 Step 8. Install the flex tube with clamps pre installed (fig 13A) on the bulkhead fitting and install 2 spring clamps 180 degrees apart as in fi
7 INSTALLING THE PUREFLOW® FUEL MODULE UPGRADE FOR FUEL MODULE WITHOUT THE IN-TANK PUMP Note: The sending unit pictured may not be the exact same
8 Step 3. Assemble the Pickup Tube as shown. Hold the assembly Next to the fuel module. Adjust the length of the pickup tube so that it is sli
9 Step 6. Install the washer on the bulkhead fitting first then tighten the Nyloc nut. Figure 7
Comments to this Manuals